Troubleshoot Retractable Awning One Arm Lower Than Other

The fabric should always rollover the top of the roller tube not from underneath.

Troubleshoot retractable awning one arm lower than other.

The fabric will retract unevenly if these parts aren t square and they should be coaxed gently back into alignment. It is critical you install one bracket between the outermost shoulders and the end of the awning. This technique works whether the awning is open or rolled up. Could be a bad strut that is hard to collapse grab the awning while out and try pushing in by hand.

There can be an obstruction in the arms or rust build up on the strut. Here s a quick look at some of the most common issues found with retractable awnings. Your awning motor has a built in thermal override to prevent overheating. Ensure that the awning s outlet is turned on if necessary via a wall switch or switch on the outlet itself.

Measure the location of the awning shoulders and transfer that to the wall or soffit. Reverse cranking direction and retract the awning in until the fabric is taut. Your perfect and peaceful space beneath the awning just will not be the same again until you can get it fixed the way it was when you first put it up. Be sure to use all supplied brackets.

The motorized awning stopped working while you were rolling in and out. If you have a broken retractable awning it can be frustrating. Ensure that the awning s power supply is properly connected. If this is hard to do it could be the strut.

To troubleshoot retractable awning arm repair you could use lubrication to make the movement smooth. Usually the clicking are the gears skipping. The awning is shipped with two brackets per arm. Pull the support arm to release the ratchet attached to the other end of the lever.

Prolonged use or in and out several times in a row can cause the motor to temporarily shut down. Next check the awning rail to ensure that it is attached snugly and hasn t shifted. Make sure the awning arms are parallel to each other and fully opened first. Release a sticky awning ratchet lever by releasing the awning lever with one hand while pulling down gently on the awning support arm with your other hand.

Some awnings plug into an outlet inside the home while others source their electricity directly from the mains without an outlet. Lastly it could be the gears in the motor housing. An awning can get beat up pretty badly even with small wind gusts. Determine your awning mounting location on the wall or soffit.