Tiled Roof Edge

L shape drip edge is a simple 90 degree bend with a flare out at the bottom of the short leg.

Tiled roof edge.

Position the first roll of underlayment at one side of the roof perpendicular to the lower edge the eave of the roof. Overlapping roof tiles are prone to break under load. The best way is to install the roof drip edge only along the eaves first then place ice and water barrier in the snowbelt or felt paper underlayment over the drip edge. As you roll out the underlay keep the bottom edge of the material aligned with the edge of the eave but above any metal or synthetic edging that may cover the borders of the eave.

To do this experienced workers lay down plywood walkways treated with foam backs when moving across a tile roof. Drip edge roof flashing types. The key to walking on a tile roof is distributing your weight over and area wider than your foot. Unless hip and ridge tiles on a clay tile roof are going to be set into a continuous bed of mortar special nailers are required to install them.

T shape drip edge is an l shaped flashing in which the long leg folds back on itself before heading down 90 degrees to form the short leg. Install roof drip edge along the eaves add underlayment then place drip edge along the gable end. However if you must walk on a tile roof we recommend stepping near the edges on overlap areas that are supported directly underneath. Ridge and hip requirements on tile roofs.

The hip and ridge boards are typically 2x3s to 2x6s set on edge to hold the trim tiles in an even plane. Never walk along the delicate edges of tile or along specially cut tiles that are difficult to replace.